KAEN DWG-3 Hydraulic Manual Pipe Bender

MODEL: KAEN DWG-3 + HHB-700A Hydraulic Manual Pipe Bender

Features:

• The moulds are made of ductile iron
  High strength, good toughness and plasticity, higher strength than ordinary gray cast iron
• Bend pipe interface
  Thickened design with smooth edges and joints with curved nozzles
• Adjustment column
  Adjust the bending amplitude of the bent object
• The maximum bending angle of the whole system is 90°
  Unable to bend non-metallic pipe, unable to bend square pipe

Procedure:

1. Turn the switch tightly with clockwise direction.
2. Loosen the bolt.
3. Add lubrication on mould and the pipe.
4. Choosing corresponding mould base on size of pipe, set mould on the top of actuating rod. Then insert the rocker on nether moulding board. Put the pipe, turn two rockers and make the groove point to the mould.
5. Turn back the upper mounding board; shake the handle of pump to make the mould press the pipe, bending the pipe until the angle is shaped.
6. After bending. Loosen  the  switch  anti-clockwise.  The  actuating  rod  would  be  back automatically. Open the upper moulding board, get out the pipe.

Model: DWG-3

Model: HHB-700A

Product Warranty

12 months Warranty

Catalogue

Download Here